Are you interested in woodworking but you don’t know where to begin? The information included here should be of benefit to you. Woodworking can seem difficult, but an experienced helping hand can make all the difference. As a matter of fact, the following paragraphs have a number of pieces of advice you can use today!

Safety is important when working with wood. Make sure that you always use tools properly and wear the proper safety equipment. Always keep safety guards in place on power tools. Ending up in the emergency room is not a good way to end a woodworking project.

It is always a good idea to have a pre-stain conditioner for the wood you’re planning to stain. This will reduce the risk of irregularities and blotches in the final product. They smooth the wood and make it possible for the stain to penetrate into the wood evenly.

TIP! Always apply a pre-stain conditioner to the wood you want to stain. A pre-stain conditioner helps keep away any irregularities or blotches in the wood.

If you will be using stain, always do a test on an inconspicuous area, or scrap of wood. This will prevent you from getting an unwanted stain color on your final product. Because wood tends to be fickle, mistakes can be avoided by testing it out beforehand.

Use stair gauges to guide your crosscuts. With a carpenter’s square these can be clamped down to match up the stair jack. Then put a mark on the notches. Put them on your carpenter’s square guide for a great cut.

Account for new tools in your budget. You may only think about the wood and overlook the tools themselves. But, if you need certain items, they can break your budget if you aren’t diligent about remembering you need them.

Create sanding blocks you can reuse. Start by cutting six blocks from scrap 3/4″ plywood for every sandpaper grit you generally use. They need to be 2.5″ X4.75″. Spray some adhesive on your blocks and on the cork tile. Stick a single block onto the cork and make sure you’re cutting the cork in a flush way using your utility knife. Put adhesive on the sandpaper sheet and then apply it to the cork blocks face down. Cut the sandpaper so it aligns with the cork and do not forget to label your blocks.

TIP! You can make your own reusable sanding blocks. Create six blocks of the same size from some plywood.

Always do a dry fit prior to gluing two pieces of wood together. It won’t be easy to adjust things as necessary if you’ve already applied the glue. Dry fitting will help you see which pieces go in which spots.

Be certain your blades are sharp before you start sawing. Dull blades can make it hard to do as much sawing as you want. It can also lead to you making an error that could cost you a lot of money, depending on the type of wood that you are using.

Make sure to purchase and wear proper ear protection. Machinery for woodworking is very loud. In fact, staying in one without ear protection for long durations can lead to hearing loss. Get a pair of inexpensive ear plugs, or buy a great pair of noise canceling headphones. Be sure that whatever you pick out is used when you’re trying to operate machinery.

If you are going to be staining your project, test on a scrap of wood or an inconspicuous area. This will help you to pick the right stain color for your project. Wood is unpredictable at times and you should do this test so that you aren’t disappointed by the results.

TIP! Test your stains on scraps of wood or inconspicuous areas of the piece you’re using. This can help you avoid surprises in case your stain color is different after you’ve applied it.

What do you do when you need to tighten a screw that is hard to reach? Dive into your toolbox. Grab a 12-point socket and your long-handle screwdriver. Place the socket on your screwdriver, then use it on the ratchet.

If woodworking is new to you, one of the most important pieces of advice to take is to thoroughly read all plans and instructions before you begin anything. Be sure you understand them through and through. If you have incomplete plans, ask at a local hardware store for advice.

Woodworking isn’t always easy, but it’s rewarding. When you see your finished piece, you will be happy that you followed through and completed something of value that will last for years to come. Use what you learned here to get started and create beautiful wooden works of art.

Stir your paint and stain, don’t shake it! Ingredients can settle to the bottom. Shaking can cause bubbles which can negatively impact your results. Make sure that you stir it thoroughly until the sediments are smoothed out and blended evenly.